"Gazelle" Gas-2705>> Running gear>> Beam of a forward suspension bracket and steering draughts>> Зaмeнa hinges of draughts
Replacement of the hinge of longitudinal steering draught
Replacement of the hinge of longitudinal steering draught is necessary for making in a following order:
- расшплинтовать and to turn on nuts of fastening of steering bent for сошке the steering mechanism and to a rotary fist;

Fig. 6.25. Выпрессовка a finger of the hinge of steering draughts a universal stripper




- выпрессовать fingers from conic apertures by means of a universal stripper (fig. 6.25) or to beat out a hammer through a copper lining;

Fig. 6.26. Выпрессовка the hinge of steering draughts: 1 — the plug; 2 — the hinge; 3 — draught or a tip; 4 — a protective cap




- On a press by means of the basic plug 1 (fig. 6.26) выпрессовать the hinge from draught with the appendix of effort to a finger with preliminary навернутой to level of an end face a nut. Thus the protective cap 4 from the hinge case is simultaneously pressed;
- To clear a nest surface under the hinge in longitudinal draught;

Fig. 6.27. Запрессовка the hinge of steering draughts




- запрессовать the new hinge in longitudinal draught by means of the basic plug and a press heel (fig. 6.27);

Fig. 6.28. Запрессовка a protective cap of the hinge


- To take a new protective cap and to put on it the case and a finger of the hinge by means of a universal stripper and a washer (fig. 6.28), preliminary having put in it from 1 to 1,5 г greasings;
- To fix a cap on a finger a lock ring. At assemblage of the hinge not to suppose mechanical damages of a rubber cap;
- To establish draught on the car in sequence, return dismantling.
Replacement of the hinge of cross-section steering draught
Replacement of the hinge of cross-section steering draught to carry out in such order:
- расшплинтовать and to turn away a nut of fastening of the hinge to the lever of a steering trapeze;
- выпрессовать a finger from a conic aperture of the lever by means of a universal stripper (fig. 6.25 see) or to beat out a hammer through a copper lining;
- To turn away a bolt of a collar of steering draught;
- To curtail a tip from the carving end of draught.
Further hinge replacement is made in the sequence specified for longitudinal draught.
The sizes of interfaced parts of a forward axis and steering draughts are resulted in tab. 6.4.

Table 6.4. The sizes of interfaced details of a beam of a forward suspension bracket and steering draughts, mm